The appearance of IQOS 3.0 DUO is the same as “IQOS 3”, but the design is compact. However, the internal structure has been greatly upgraded. The usage of IQOS 3.0 DUO is the same as IQOS 3.0.
View previous articles: IQOS 3 Duo full reivew
IQOS 3 DUO (preparation before use)
1. Turn on the power
Press and hold the pocket charger button for 4 seconds. When the heater status indicator and battery indicator flash, the power is turned on.
- You don’t have to repeat this step every time you use it.
- To turn off the power, press the same button for 4 seconds. The light goes out.
- Press and hold for more than 4 seconds may cause a reset.
- When using for the first time, there may be no remaining battery, please charge it.
2, charge the charger
Use the dedicated AC power adapter and dedicated USB cable to charge. When charging, the battery indicator flashes.
- Genuine products can be purchased at IQOS online store and IQOS store.
- Make sure the door is closed.
- Make sure to plug in the AC adapter and USB cable correctly.
- Because the USB power supply of the personal computer is weak, it may not be able to charge normally.
- It takes 120 minutes to fully charge.
3. Check the battery status
If you press the pocket charger button for a short time (about 1 second), the battery indicator will light up to notify you of the charging status.
IQOS 3 DUO (easy steps)
Step 1:Charge the heating rod
Press the bottom of the door to open it. Load the heating rod and close the door to start charging.
- When the holder status indicator turns white, charging is complete.
Step 2: Insert tobacco shreds
Insert the special IQOS tobacco stick directly into the line printed on the filter , Don’t distort. Twisting may cause internal fracture of the heating blade.
Step 3: Heating shredded tobacco
Press and hold the button until the heating rod vibrates and the indicator light flashes white.
Step 4: Ready!
When the heating rod vibrates twice and the indicator light turns white, you are ready to go.
Step 5: Attention before the end
With 30 seconds left, the heating rod will vibrate twice and the indicator light will flash white.
Step 5: Take out the tobacco
When the light is off, slide the lid up and pull the tobacco straight out without twisting. Twisting may cause internal fracture of the heating blade.
To continue using the second one, please start with STEP 2 again.
Step 7: Put the heating rod into the pocket charger.
Cleaning makes it difficult for stubborn stains to adhere to the heating blade, thereby maximizing the performance of IQOS. Clean each pack of shredded tobacco once.
- Is this a malfunction? If you think so, please try to reset first.
- This is the only difference in product registration. Further reliable quality assurance.
